AUTOMATION & RECORDING

LFO Tool

The LFO tool allows you to draw LFO shapes in the Event Editor.

LFO is drawn only in the selected time range. If nothing is selected, the LFO tool will select automatically the first bar.

1. Start

• Value - Sets the value of LFO.
• Range - Sets the range between the lowest and highest points in the LFO shape.
• Speed - Sets the frequency of the LFO (i.e. its speed). Right-click for a menu with tempo-based presets.

2. End

Contains the same parameters as the Start section. When you turn on the led in the top left corner of this section, LFO's settings will vary from those in the Start section to those in the End section. If led is turned off, then only the settings from the Start section are used.

3. Shape

Sets the shape of the LFO - sine, triangle or square (to select a shape click any of the icons at the top left corner of this section). Phase knob sets the phase of the LFO (basically this moves the LFO shape left and right).