|
MIXING & EFFECTS
Fruity Chorus
 Fruity Chorus is an FL Studio
exclusive plugin developed by Smart
Electronix. Chorus is an effect created by the slight detuning
of multiple copies of the same sound (similar to a choir of
voices).The controls contain parameters that affect the rate, time
offset, shape and depth of detune. |
Parameters
- Delay - Sets the minimum delay between the
chorus voices. The chorus delay will be swept between delay and
delay+depth. Range: 0 to 30 milliseconds. For 'deep' chorus effect,
set this parameter to low values.
- Depth - Controls the chorus delay modulation.
The chorus delay will be swept between delay and delay+depth. If
this value is zero, the chorus will remain 'static' as the delay
modulation will stay constant. Setting the 'Depth' to higher values
will create heavier modulation.
- Stereo- Controls widening of the stereo image.
If set to 0, the LFO on the left and right channel will be in
perfect synchronization. At 180 degrees the left and right channel
will be 100% out of phase, i.e. left channel will reach maximum
when right channel is at minimum. Range: 0 to 360 degrees. Try
setting 10 degrees for subtle stereo enhancement.
- LFO 1 Freq / LFO 2 Freq / LFO 2 Freq - Sets
LFO modulation speed.
- LFO 1 Wave / LFO 2 Wave / LFO 3 Wave -
Waveform of the LFO. Multi-sine is a mix of a normal sine wave and
one three times its speed.
- Cross Type - Defines whether the plugin works
on the lower or higher frequency part of the signal. Process HP
processes only high frequencies, Process LP processes only low
frequencies.
- Cross Cutoff - Cutoff frequency of the
cross-over filter.
- Wet Only - If using the chorus as a send
effect, switch this parameter to mix the pure ‘wet’ output with the
source sound.
Plugin Credits: Smart Electron:x
|
