GENERATORS

Fruity DX10

DEMO ONLY: Fruity DX10 comes as a demo version in FL Studio and needs to be purchased separately so you can save projects containing Fruity DX10 channels.

Parameters

Misc Section

• Wave Brightness (WAVE) - Turning the wheel to the right adds brightness to the generated sound.
• Octave Shift (COARSE) - Use this wheel to shift the octaves of the synth.
• Vibrato LFO Rate (LFO RATE) - Sets the speed of the vibrato effect.
• Vibrato Amount (VIB) - Sets the vibrato amplitude amount (vibrato strength).

Amplitude Section

Contains controls to set the volume envelope of the sound

• Envelope Attack (ATT) - Sets the attack (fade in) length of the synth.
• Envelope Decay (DEC) - Sets the decay (fade out) length of the synth.
• Envelope Release (REL) - Sets the release (fade out after key is released) length of the synth.

Modulation Sections

• Coarse Tune (COARSE) - Use to set the modulation speed (pitch).
• Fine Tune (COARSE) - Use to fine tune the modulation speed (pitch).
• Modulation Velocity (VEL.SENS) - Sets the velocity of the modulation.
• Pass Though (THRU) - Turn to the right to mix the modulation wave with the output (apart from modulation of the signal). This control is available only for the first modulator.
• Amplitude Init (INIT) - The start amplitude of the modulation.
• Amplitude Time (TIME) - Time needed for the modulation amplitude to reach the sustain level (see below).
• Amplitude Sustain (SUS) - The sustain amplitude of modulation.
• Amplitude Release (REL) - The time needed for the modulation amplitude to reach zero after key release.

Show/Hide Keyboard switch

Plugin Credits: Paul Kellett (original code), Frederic Vanmol (conversion), Didier Dambrin (interface)