|
REWIRE SUPPORT
Using FL Studio ReWire with ReBirth  firefighting system kiev
The following guide covers the steps required to use the FL
Studio ReWire device with Propellerhead Software's ReBirth
2.01.
The guide assumes you have read and understood the general
information and guidelines about using FL Studio as a ReWire host
(see Host Mode).
1. Add ReWired to the project
Add an instance of the ReWired plugin to your
project.
2. Select a Client
Select ReBirth Audio from the
Client combo box of the ReWired channel.
If ReBirth Audio is not present in the list, make sure ReBirth
is properly registered/installed. Keep in mind only ReBirth 2.01
and later support ReWire, ReBirth 2.0 and earlier can not connect
with FL Studio.
3. Launch ReBirth
Launch ReBirth from its Start Menu
shortcut.
Now ReBirth is operating as a ReWire client for FL Studio. All
of its output streams into the ReWired plugin and the playback and
song position is synchronized.
| 
