WAVE EDITOR

Basics

This page covers the basic interface of the integrated wave editor.

1. Main Toolbar
2. Large View
3. Full Preview

Toolbar

The toolbar contains a set of buttons performing various operations in the wave editor. See Toolbar.

Large View

This area displays the wave selection from the Full Preview (see below).

In selection mode, you can select part of the wave (to be processed), adjust the loop points (by dragging the handles marked with S and E). To select only left or right channel, move the cursor up or down until you see an L or R ext to your cursor. Now select as normal and only the left or right channel will be selected. If you right-click, you can see the wave editor's pop-up menu (for more information, see Pop-Up Menu).

In zoom mode, drag to select an area with your mouse and the view zooms to display your selection. Right-click to zoom out.

Full Preview

This area displays the entire wave and allows you to select which section is shown in the Large View. Drag the left and right edges of the white rectangle to set the visible area.